B - Ardiehl.de

FUEL INJECTION PUMP IDLER GEAR
Removal and Installation
Remove the timing gearcase cover. (See Page 7–69.)
Remove the idler gear. (See Page 7–71.)
Remove the bolt at the fuel injection pump idler gear [A].
Installation: Tighten the bolt to 72–87 ft.–lbs. (98–118
Nm) torque.
Remove the idler gear and bearing [B].
If the bearing needs replacement, remove the snap ring
at the bearing [C].
Use a press to remove and install the new bearing.
Bearing Installation
When installing the new bearing, make sure the
projection and height is correct [D].
Projection – 0.016–0.024 inch (0,4–0,6 mm)
Height – 0.933–0.945 inch (23,7–24 mm)
A
B
C
D
Projection
B–08930
B–08927
B–08955
B–08896
853, 853H BICS Loader
–7–73– Service Manual