B - Ardiehl.de

SEAT BAR SENSOR (Cont’d)
Seat Bar Sensor Test
Use MEL1428 Sensor Tester for the following procedure:
Turn the key to the ON position. DO NOT START THE
ENGINE.
Disconnect the seat bar sensor connector (Item 1) [A].
Connect MEL1428 Sensor Tester (Item 1) [B] inline as
shown to the seat bar sensor connectors. Also see inset
[B].
The power light (Item 1) [C] on the sensor tester will
illuminate.
Lower the seat bar. The sensor test light (Item 1) [D]
should illuminate.
Raise the seat bar. The sensor test light (Item 1) [D]
should go off.
If the above tests fails, there is a problem with the seat bar
sensor.
Refer to Page 8–3 for the correct procedure to inspect the
Seat Bar Sensor.
Refer to Page 5–1 for seat bar removal and installation
procedure.
A
B
C
D
1
1
1
P–04702
P–04701
P–04700
P–04698
P–04699
853,853H BICS Loader
–8–13– Service Manual
1