B - Ardiehl.de

PEDAL INTERLOCK LINKAGE (Cont’d)
853, 853H BICS Service Manual #6724012 – Hydraulic System Section Part 3 of 3
Removal and Installation (Cont’d)
Remove the panel from the loader frame [A].
Install the mounting bolts (Item 1) [B] through the back of
the panel as shown.
Pedal Interlock Linkage Adjustment
Check the pedal interlock linkage so it is free and locks
both pedals.
Check that the tab (Item 1) [C] on the linkage, slides into
the slot on the interlock and holds the pedal in locked
position.
If not, loosen the bolts and adjust the tab for correct
engagement.
Tighten the bolts to 25–28 ft.–lbs. (34–38 Nm) torque.
AVOID INJURY OR DEATH
Adjust locking tabs on pedal control linkage so
that lift and tilt control pedals are locked in
neutral when the seat bar is up.
W–2104–1285
The locking tab should fit into the slot of the interlock as
shown in figure [D], when adjusted correctly.
–2–70–
A
B
C
D
1
1
P–01215
P–01212
P–01214
P–04051
853, 853H BICS Loader
Service Manual