B - Ardiehl.de

HYDROSTATIC MOTOR (Cont’d)
Assembly
When making repairs on hydrostatic and
hydraulic systems, clean the work area before
disassembly and keep all parts clean. Always
use caps and plugs on hoses, tubelines and
ports to keep dirt out. Dirt can quickly damage
the system.
I–2003–0284
NOTE: Always use new O–rings, gaskets and seals
when assembling the hydrostatic motor.
If the bushing was removed use a hydraulic press and
bushing driver tool to install the new bushing.
Install new O–rings in the bore of the mounting flange [A].
Install new O–rings on the housing [B].
Install the drive shaft [C].
Make sure to keep the rollers in the geroler and install the
geroler [D].
NOTE: See Page 3–26 for timing of the motor when
installing the valve, valve drive and geroler.
Revised June 96
A
B
C
D
B–04636
B–08730
B–08736
B–08739
853, 853H BICS Loader
–3–23– Service Manual