B - Ardiehl.de

HYDRAULIC CONTROL VALVE (Cont’d)
Removal and Installation (Cont’d)
Disconnect the tubeline (Item 1) [A] from the tee fitting
and control valve lift section.
Disconnect the inlet hose (Item 1) [B].
Disconnect the tubeline (Item 2) [B] from the lift section.
Disconnect the charge tubeline (Item 1) [C] to the tilt lock
valve.
Disconnect the two tubelines (Item 2) [C] from the tilt
section.
Disconnect the auxiliary tubelines (Item 3) [C].
Disconnect the charge tubeline (Item 4) [C].
Disconnect the outlet tubeline (Item 1) [D].
Remove the control valve mounting bolts (Item 2) [D].
Installation: Tighten the mounting bolts to 25 ft.–lbs. (34
Nm) torque.
Remove the control valve from the mounting bracket.
Always clean up spilled fuel or oil. Keep heat,
flames, sparks or lighted tobacco away from
fuel and oil. Failure to use care around
combustibles can cause explosion or fire
which can result in injury or death. W–2103–1285
A
B
C
D
4
2
1
2 2
3
2
1
1
P–04780
P–04786
P–04788
P–04803
853, 853H BICS Loader
–2–29– Service Manual
1
2