B - Ardiehl.de

FAN DRIVE TENSION PULLEY
Removal and Installation
Remove the fan drive belt.
Remove the idler pulley bolt (Item 1) [A].
Remove the spacers, bolt and washers from the arm [B].
Installation: Put a small amount of grease around the
outside edge (Item 1) [B] on the grease rings (both sides).
–
Remove the bolt (Item 1) [C] & [D].
Remove the thrust washer (Item 2) [D], O–rings (Item 3)
[D] and spring (Item 4) [D].
Check all parts for damage or wear and replace them as
needed.
Reverse the removal procedure to install the tension
pulley.
NOTE: When making repairs, replace the bronze
bushing (Item 5) [D] with a new style nylon
bushing. Clean all parts and assemble dry.
Do not lubricate. (See Parts Manual for
correct part numbers.)
Revised June 97
–7–12–
A
B
C
D
4
P–04956
5
3
1
3
2
1
P–04954
1
P–00581
P–04955
1
N–00303
853, 853H BICS Loader
Service Manual