B - Ardiehl.de

FAN GEARBOX (Cont’d)
Disassembly
NOTE: When repairing the gearbox order the
following as needed:
1. Complete Assembly
2. Long Housing Assembly
3. Long Housing
4. Short Housing Assembly (See Note
Below)
5. Internal Parts
NOTE: The short housing is only available as an
assembly. See the parts identification page
(Page 7–14) for reference (Order parts from
Melroe Parts Sales).
NOTE: Be sure to count the number and thickness of
shims during disassembly. Install the shims
in the original location during assembly.
Remove the fan and blower housing mounting plate. (See
Page 7–13.)
Long Housing
Loosen the set screws (Item 1) [A] and remove the pulley
(Item 2) [A].
Remove the long key (Item 3) [A].
Remove the four mounting bolts and the part number tag
[B].
Remove the oil from the gearbox.
AVOID INJURY OR DEATH
Wear safety goggles to prevent eye injury
when drilling or grinding.
W–2108–1186
Drill an 1/8 inch (13 mm) hole in the seal. Use a slide
hammer tool to remove the seal [C].
Remove the small snap ring [D].
A
B
Part Number
Tag
C
D
3
1
2
P–03005
P–02983
P–02999
P–02964
853, 853H BICS Loader
–7–15– Service Manual