B - Ardiehl.de

HYDROSTATIC PUMP (Cont’d)
Disassembly (Cont’d)
Remove the end housing with the shaft assembly [A].
Remove the gasket [A].
Remove the swashplate journal bearings from the end
housing [B].
◊ Remove the snap ring at the seal [C].
◊ Use an electric drill with a magnetized or greased bit
to make a small hole in the seal [D].
NOTE: Be careful not to damage the bearing behind
the seal.
◊ Front Pump
♦ Rear Pump
Revised June 96
A
B
C
D
CD–00071
CD–00090
CD–00092
CD–00093
853, 853H BICS Loader
–3–41– Service Manual