Pneumatic Clean Series

Sine Cylinder 10-REC/11-REC101Specific Product PrecautionsBe sure to read before handling.Refer to pages 7 to 16 of Front matter for safety instructions and common precautions for clean series andpages 2 to 7 for common precautions for actuators.CautionSpeed ControlqThe throttle type of SMC's speed controller (Series 10-AS) isrecommended.Recommended speed controllers10-11-10-11-10-11-10-11-ModelModelElbow type Straight union type In line typeREC20 10-AS2201F-01-06-X214 10-AS2301F-01-06-X214 10-AS2001F-06-X214REC25 10-AS2201F-01-06-X214 10-AS2301F-01-06-X214 10-AS2001F-06-X214REC32 10-AS2201F-01-06-X214 10-AS2301F-01-06-X214 10-AS3001F-08-X214REC40 10-AS3201F-02-08-X214 10-AS3301F-02-08-X214 10-AS3001F-08-X214wAlthough speed adjustment is possible with meter-in andmeter-out speed controllers, smooth acceleration anddeceleration may not be achieved.In case the mounting orientation is not horizontal, a systemwith a pressure regulating circuit on the lower side isrecommended. (It is also effective to shorten start-up delay inrising and for energy conservation.)CautionCushion AdjustmentqCushion adjustment mechanism is not provided.It is not necessary because the model can perform smoothacceleration and deceleration in a wide range of strokeswithout an adjusting cushion.CautionRelief PortqThe clean series is not provided with hexagon socket headscrews attached to the standard series. Therefore, theproduct can be used as a relief port without any changes.The standard product looks like a clean series product whenthe hexagon socket head screws are removed. Be careful,however, since the rod seal A and grease are not the same,the required performance may not be achieved.82