Pneumatic Clean Series

Series 10-SZ3000How to Order5 Port Solenoid ValveSerial Transmission Type26910- SS5Z3—60S Q D — 05 U —Compatible equipmentDeviceNet and Omron CorporationQCompoBus/D compatibleOMRON Co.: CompoBus/SR1 (16 outputs) compatibleOMRON Co.: CompoBus/SR2(8 outputs) compatibleMitsubishi Electric Corporation:V CC -Link compatible20 type manifold: Top piping/F 10-SS3YJ3-20- stationsNKE Corporation: UNI wire HH system compatibleCorporation: S-LINK systemJ1 (16 outputs) compatibleCorporation: S-LINK systemJ2(8 outputs) compatibleO Without SI unitSI unit mounting positionD D side• Specify also for types without SI unit.Valve stationsSymbol StationsRemark(s)02 2 stationsDouble wiring specifications08028 stations2 stationsSpecified wiring(Up to 16 solenoids possible)16 16 stationsNote 1) Double wiring specifications:A single, double or 3 position/4 position solenoidvalve can be used on any station of the manifold.Note 2) Confirm the wiring specifications in the manifoldspecifications:(That use of a double or 3 position/4 positionvalve will be impossible in a position specifiedfor single solenoid wiring.)Note 3) Up to 9 pieces of solenoids are available withR2 and J2.How to Order Manifold Assemblies (Example)··· ······ ···Representation (OMRON Co. compatible serial unit)Supply/Exhaust block mounting positionU U side (2 to 10 stations)D D side (2 to 10 stations)B Double side (2 to 16 stations)∗M Special specifications∗ In the case of special specifications,indicate separately on a manifoldspecification sheet.Note) Up to 3 supply/exhaust blocksin total can be mounted.Contact SMC if 4 or more are tobe mounted.OptionWhen a DIN rail longer than thespecified stations is necessary,indicate the number of requiredstations.Supply/Exhaust block fitting specificationsNil Straight unionL Elbow fitting (Upward)B Elbow fitting (Downward)Pilot specificationsNil Internal pilot specificationsR External pilot specificationsSupply/Exhaust block assembly(U side mounting)Double solenoid (24VDC)10-SZ3260-5LOZ-C6 (3 set)Single solenoid (24VDC)10-SZ3160-5LOZ-C6 (2 set)10-SS5Z3-60SR1D-05U-C6··········1 set (Manifold part No.)∗ 10-SZ3160-5LOZ-C6··········2 sets (Single solenoid part No.)∗ 10-SZ3260-5LOZ-C6··········3 sets (Double solenoid part No.)Stations···3 2 1∗ To order valves and options mounted onto the manifold at the factory,prefix the part number of the solenoid valve and other equipment withan asterisk (*).• The layout of valves starts with station 1 on the D side.• Specify the valves to be installed below the manifold part number, startingfrom station 1 and proceeding in order as shown in the drawing. If the layoutis complicated, give descriptions on a manifold specification sheet.U side D sideSerial unit(U side mounting)CautionBe sure to read before handling. Refer to pages 7 to 16 of Front matter for safety instructions and commonprecautions for clean series and pages 236 to 238 for common precautions for directional control valve.250