Pneumatic Clean Series

Digital Pressure Switch with Backlight 10-ZSE6B/10-ISE6B657Specific Product PrecautionsBe sure to read before handling.Refer to pages 7 to 16 of Front matter for safety instructions and common precautions for clean series andpages 616 and 617 for common precautions for pressure switches.WiringWarningq Voltage resistanceVoltage resistance between the metal fitting and the leadwire of the switch is 250V. Do not apply voltage potential inexcess of 250V.Cautionq Ground the piping when induction noise is expected to begenerated from the piping.WarningPressure sourceq Use of toxic, corrosive or flammable gasesThe pressure sensor and fittings of the switch are made ofSUS630 and SUS304. Do not use toxic or corrosive gaseswith the switch. Since the switch is not rated as explosionproof, also do not use flammable gases.w Operating fluidThe fluid contact portions are made of SUS630 (pressuresensor) and SUS304 (fittings). Use fluid that will not corrodethese materials. The anti-corrosive performance of SUS630and that of SUS304 are approximately at the same level. Forreference, fluid and gases that will not corrode SUS 304 areshown below.CautionOtherq This product is equivalent to Series ZSE6B/ISE6B but isblown with air and double packed in a Class 100 cleanroom.w Mounting the panel1) Insert the panel adapter A from the front of the panel.2) Fix Adapter A firmly with Adapter B from the back of thepanel.3) Insert the pressure switch into the panel adapter A fromthe rear side of the panel.4) Secure the pressure switch with the mounting bracket.Panel adapter APanel adapter BPressure switchDryingairAir containing drainageHydraulic fluid (JIS-K2213)Silicon oil (JIS-K2213)Lubricating oil (JIS-K6301)Fluoro carbonCarbon dioxideAmmoniaArgonNitrogen gasMounting brackete Helium leak testThe welded section is helium leak tested. SMC recommendsTSJ fittings such as ferrules by Crawford Fittings (Swagelok ® )or URJ fittings (With seal, gland, etc.) such as packing orglands by Cajon (VCR ® fittings). When using fittings of otherbrands, apply a helium leak test at the welded section.638