Pneumatic Clean Series

452Flow Control Equipment/Specific Product PrecautionsBe sure to read before handling. Refer to pages 7 to 16 of Front matter for safety instructionsand common precautions for clean series. Refer to the main text for precautions for each series.Handing on One-touch FittingsCautionqRefer to page 2.0-7 and 2.0-8 in Best Pneumatics rfor One-touch Fittings.CautionSeries 10-ASDqSingle acting cylinderWhen single acting cylinder is controlled, cylinderretracted speed depends on operating condition.Confirm the maximum retracted speed mentioned in thetable below.SpeedCylindercontrollerSolenoidvalveASD230F CJ2 VJ500ASD330F CM2 VZ500TubingTU06041mTU06041m•Cylinder extending speed: 100mm/s•Needle fully open at meter-out side100mm/sOperationSilencerAN110-01AN110-01Max. retracted speed mm/s100 200 300ø16ø10ø6Cylinder sizeø20ø25ø32 Cylinder size∗At pressure 0.5Mpa, temperature 20°CWarningSelectionqPlease confirm if it is compatible with PTFE.PTFE powder (polytetrafluoroethylene resin) is included insealant. Confirm if the use of it may cause any adverse effectin the system.WarningMountingqTo install/remove the Flow Control Equipment,tighten/loosen at wrench flat B as close to thethread as possible using the appropriate wrench.Do not apply torque at other points as the product may bedamaged. Rotate Body A manually for positioning afterinstallation.wDo not use universal type fittings for applicationsinvolving continuous rotation.It may cause failure of the fittings.CautionTightening Torqueq Suitable torque for tightening fittings is shown inthe table below. For standard installation, turn 2to 3 turns using tool after fastening by hand. Takecare not to damage the product by over torque.Air Line EquipmentRetracted speed(Reference) Recommended circuit to accelerate the return speed.When extended speed is low speed andretracted speed is required high speed, belowcircuit with 3 port is recommended.Male threadM3M51/81/43/81/2Appropriate tightening torqueNm1/4 turn after manual tightening1/6 turn after manual tightening7 to 912 to 1422 to 2428 to 30Hexagonal width Adjustable spannermm nominal mm4.5812171924Tightening Torque for Lock NutsCaution—100150200200200qSuitable tightening torque for a hexagon lock nut isshown in the table below. For standard installation,turn 15 to 30° using tool, after fastening by hand.Pay attention not to over torque the product.Note) Use AS-F series as speed controller.Body sizeM3M51/81/43/81/2Appropriate tightening torqueNm0.070.311.5410433