Pneumatic Clean Series

DimensionsHollow Fiber Membrane Air Dryer 10-IDG8365628OUTIN(67.5)5341Options-R Indicates air flow directionPurge airø8(Insert fittings)Mount on IN side.The minimum distancefrom the equipment: 20Bracket mounting holeM4 X 0.7 depth 5836227.50IN1 47OUT14 7(53.5)Purge air(232)ø8(Insert fittings)165181Specific Product PrecautionsBe sure to read before handling.Refer to pages 7 to 16 of Front matter for safety instructions and common precautions for clean series. Refer to pages 590 and591 for common precautions for air preparation equipment.CautionOperating Conditionsq Be sure to use the product within the specified ranges.w Read the instruction manual included with the product thoroughlybefore actually using the product.e Avoid use of corrosive gases and compressed air containing organicsolvents or use of the product in an environment where suchsubstances are present.MountingCautionq The mounting orientation is free.w Be sure to install a mist separator and micro mist separator at the inletof the membrane air dryer. Any oil mist or water drops contained inthe inlet air will lower the performance.e When a drain piping is connected to the mist separator or micro mistseparator installed at the inlet of the membrane air dryer, use a tubewith an O.D. of 10 mm (With I.D. of 6.5 or more) and a length of 5 mor less. Do not fold the tube or bend it in the upward direction.r Do not obstruct the purge air discharge outlet.t Install a regulator on the secondary side of the membrane dryer.y Use a tube with an O.D. of 8mm (An I.D at least 5mm) and a lengthnot exceeding 10m.CautionMaintenanceq Set the pressure of the compressed air at zero before maintenance or inspection.w Verify whether the membrane air dryer is functioning normally by observing the color ofthe dew point indicator.[When the color of the dew point indicator is blue: The equipment is functioningnormally.][When the color of the dew point indicator is pink: The dew point temperature is high.](Outlet air flow is humid.) Note) The atmospheric pressure dew point is –10°C orhigher.It takes approximately 1 hour after air is introduced for the color or the dew pointindicator to change.e If the color of the dew point indicator is brown, it indicates a large amount ofoil contamination in the membrane air dryer. In such a case, replace the dewpoint indicator and the membrane module. If the particles inside the dew pointindicator have been crushed, replace the dew point indicator.r Confirm that the drainage accumulated between the mist separatorand micro mist separator installed on the inlet side of the membraneair dryer is properly exhausted.t Replace the elements of the mist separator or the micro mist separatorinstalled on the inlet side of the membrane air dryer approximately 2years after they are put to use. Even within this period, they must bereplaced if the unit's pressure drop reaches 0.2 MPa.y For the purpose of maintenance and inspection, install a pressuregauge at the inlet and outlet sides of the membrane air dryer(Combination unit).Air PreparationEquipment609