Pneumatic Clean Series

5 Port Solenoid Valve Plug-in Type 10-SQ2000284ModelSeriesNumber ofsolenoidsModelFlow characteristics Note1)14/2 (PA/B) 4/25/3 (A/BR1/R2)C[dm 3 /(s·bar)] b Cv C[dm 3 /(s·bar)] b CvResponse time ms Note2)Standard: 1W Low wattageWeight(g)2 positionSingleDouble(Latching)Rubber seal 10-SQ2131Rubber seal 10-SQ22312.32.30.170.170.510.513.13.10.180.180.710.7124 or less 31 or less31 or less —14014010-SQ2000Closed center Rubber seal 10-SQ23311.90.170.461.80.290.4734 or less 44 or less1753 positionExhaust centerRubber seal 10-SQ24311.90.170.463.10.140.6534 or less 44 or less175Pressure center Rubber seal 10-SQ25312.50.170.561.80.300.4734 or less 44 or less175Note1) Values for the top ported cylinder port size of C8. The side ported type is 10% smaller.Note2) According to JISB8375-1981 (At supply pressure of 0.5MPa with light/surge voltage suppressor.The value differs with the pressure and the quality of air.)SpecificationsManifold SpecificationsValve specificationsSolenoidspecificationsValve typeFluidMaximum operating pressureSingleDouble (latching)3 positionMinimumoperatingpressureRubber sealAir,Inert gas0.7MPa0.15MPa0.18MPa0.2MPaNote1)Ambient and fluid temperature–10 to 50°CLubricationPilot valve manual overrideNote2)Vibration/Impact resistanceEnclosureRated coil voltageAllowable voltage fluctuationType of coil insulationNot requiredPush type (tool required)/Locking type (tool required)/Slide locking type (manual type)30/150 m/s 2Dust proof12V,24VDC±10% of rated voltageEquivalent to class BPower consumption(Current)24VDC12VDC1W DC (42mA), Note3) 0.5W DC (21mA)1W DC(83mA), Note3) 0.5W DC (42mA)Note 1) Use dry air to prevent condensation when operating at a low temperature.Note 2) Vibration resistance: No malfunction resulted from a one-sweep test between 8.3 and 2000Hz.The test was performed on the axis and right angle directions of the main valve and armature, forboth energized and de-energized states.Impact resistance: No malfunction resulted in an impact test using a drop impact tester.The test was performed one time each in the axial and right angle directions of the mainvalve and armature, for both energized and deenergized states (specification).Note 3) Values for low wattage (0.5W)DirectionalControl ValveBase model10-SQ2000series10-SS5Q23--P, RC10(For ø10)Piping specificationsPort sizePipingSideNote2)TopA, BPort sizeNote1)C4 (For ø4)C6 (For ø6)C8 (For ø8)L4 (For ø4)L6 (For ø6)L8 (For ø8)Applicablesolenoidvalve10-SQ231Connection typeF kit: D-sub connector26PP kit: Flat ribbon cable20PJ kit: PC wiring system compatibleflat ribbon cableS kit: Serial transmissionNote 1) The inch size one-touch fittings are also applicable.Note 2) Can be changed to side ported specification.Note 3) The maximum number of stations can be increased by adopting an optional special wiring specification.Note 4) Except valves.Note3) Note4) Note4)Applicablestations1 to 12 stations1 to 12 stations1 to 9 stations1 to 8 stations1 to 8 stations5 stationsweight (g)580580580650Weight increaseper station (g)35353535265