Pneumatic Clean Series

Dual Rod Cylinder/Compact Type 11-CXSJ/12-CXSJ104Auto Switch/Proper Mounting Positions for Stroke End Detection11-12-CXSJ6BD(mm)11-12-ACXSJ10BCDSymbolANote1) BCDD-A9318.9(20.2)—14.4(15.7)6.4(7.7)D-F922.9(24.2)2.1(0.8)12.9(11.6)7.9(9.2)Note1) For D-A93, only electrical entry fromoutside (D dimension) is available.Note2) Dimensions in parentheses are for12-CXSJ6.ActuatorAAuto switch mounting dimensionsCSymbolANote1) BCDD-A9330.2(31.3)—25.7(26.8)5.2(6.3)D-F934.2(35.3)3.3(2.2)24.2(25.3)6.7(7.8)Note1) For D-A93, only electrical entry fromoutside (D dimension) is available.Note2) Dimensions in parentheses are for12-CXSJ10.(mm)A3B1A2B2(mm)A1D-A93 type(Reed switch)D-F9(Solid state switch)Switch modelD-A93D-F9SymbolA1A2, A3B1B2Bore size6, 100.40.30.40.3Specific Product PrecautionsBe sure to read before handling.Refer to pages 7 to 16 of Front matter for safety instructions and common precautions for clean series andpages 2 to 7 for common precautions for actuators.Adjust the bolt holder position using a hexagon wrench with 3mmwidth across flats so that it will not protrude from the cylindermounting surface. (An approx. 0.5mm recession might be aguideline).Be careful if the bolt holder position is not adjusted properly, it willinterfere with the switch groove to hinder switch mounting.MountingAASectionA—ABolt holder (movable)Approx.0.5 or less85