Pneumatic Clean Series

614Mist Separator 10-AMSpecific Product PrecautionsBe sure to read before handling.Refer to pages 7 to 16 of Front matter for safety instructions and common precautions for clean series. Refer topages 590 and 591 for common precautions for air preparation equipment.CautionDesignq Design a layout so that the mist separator is installed in anarea that is less susceptible to pulsation. The element couldbe damaged if the difference in internal and externalpressures exceeds 0.1 MPa.w Use 10-AM as a prefilter of 10-AME and 10-AMF. (The airfrom 10-AM outlet cannot be used in a clean room.)e The bracket provided with the product is for supporting theproduct body. It cannot support the piping or otherconnection items. If these items need to be supported,provide an additional support.CautionMaintenanceq The element must be replaced when the pressure dropreaches 0.1 MPa or when two years have passed since theoperation start, whichever is earlier.w When it is time to replace the element, immediately replace itwith a new one. At the same time, also replace the O-ringand gasket with new parts.e Discard the drainage before the drainage level reaches thecenter of the sight glass. If the drainage is not discardedproperly, it will flow over to the secondary side.CautionMountingq Confirm the compressed air flowdirection and the "" markindicating the inlet of the productbefore piping works. It cannot beused if connected in the oppositedirection.INOUTw Make sure to install this product on horizontal piping. If it isinstalled diagonally, laterally or upside down, the drainagethat is separated by the element will splash on the secondaryside.e Since the drain exhaust port is designed for the drain guidespecification (Symbol -J), installation of a ball valve andpiping for drain exhaust will be necessary.Air PreparationEquipment595