Pneumatic Clean Series

Precision Clean Regulator SRP670OptionPressure GaugeDimensions44.526.5 1014Handling Instructions for Pressure Gauge with Limit Gauge IndicatorsRemoving the coverHold the outer edge of the front cover with thefingers. Push and turn it counter clockwise(about 6 to 7mm) until it stops, and then pull itout.ø42SpecificationsItemModelPort sizeOperating temperature rangeAccuracyCalibration angleParts washing(Fluid contact parts)Assembly and adjustmentenvironmentOil free/Water freeFluid contact partsCaseMaterialClear coverInternal partsWeightModelR1/8G46--01-SRA G46--01-SRBR1/80 to 60°C (With no condensation)±6%F.S.270°Precision wash General degreaseGeneral manufacturingClean roomlineOil free/Water freeSUS316SUS304 (Black melamine coating)Polycarbonatebrass80gSetting the indicator needlesMovement of the indicator needles should bedone with the finger tips. If a small screw driveror similar item is used, take care not to bendthe indicator needles or scratch the gauge dial.There are two green indicator needles whichare to be adjusted to the upper (Up to 0.6MPa)and lower limits of the pressure gauge.0.2Upper limit 0.6 MPa0Installing the coverAfter setting the indicator needles, thecover is replaced to its original position.This is accomplished by aligning the notchat the top of the black case with the cutoutin the cover, and then pushing the coverback into position.Rotate the cover clockwise until it stops(approx. by 6 to 7mm). Confirm that it issecured.0.40.6USE NO OILMPa0.81ModelG46-2-01-SRAG46-2-01-SRBG46-4-01-SRAG46-4-01-SRBPressure rangeMPa kgf/cm 20 to 0.2 0 to 20 to 0.4 0 to 4IndicatorunitMPa646