Pneumatic Clean Series

Digital Pressure Switch 10-PSE643Specific Product PrecautionsBe sure to read before handling.Refer to pages 7 to 16 of Front matter for safety instructions and common precautions for clean series andpages 616 and 617 for common precautions for pressure switches.WarningWiringq If a switching regulator is to be used for the power supply,ground the FG.w Keep the input signal ON for 10 ms or longer.CautionOtherq The delay for power on reset of the controller is 0.5 seconds.The output circuit is not active immediately after the power isconnected.CautionMountingq The front plate is equivalent to IP66 rating. However, watermay invade if the panel mount adapter is not secured firmlywith screws. Tighten the screws as shown in the figurebelow.w As illustrated below, hook the nail on the bottom of the bodyon the DIN rail and press down in the direction of the arrow.To remove the body from the DIN rail, lift the switch up with abladed screwdriver, etc. in the direction of the arrow. Refer tofigure 2b.e Be careful not to apply excessive force to the wiring duringmounting on panel or DIN rail.Panel mountFigure 1Tighten another 1/4 to 1/2 turn after contacting the panel.Mounting on DIN railRemoval from DIN railFigure 2aFigure 2b624