Pneumatic Clean Series

Series10-AWDHow to OrderMicro Mist Separator Regulator521Clean seriesBody size30 — 3/840 — 1/2Port size02 — Rc1/403 — Rc3/804 — Rc1/210 - AWD 40 00 - 02 BG9 - 1 J N RAccessory (Option)Nil — NoB — BracketG9 — Pressure gaugeSet pressureNil — 0.85MPa settings(Standard specifications)1 — 0.2MPa settingsSame as the 0.85MPa setting except for the adjustment spring.The upper limit of the secondary pressure may be larger by0.2 MPa or more.With drain guide(Without valve mechanism)Non-relief type(Standard specifications)ModelOptionsNil — Flow direction: Left Right (Standard)R — Flow direction: Right LeftSpecifications502Model10-AWD3000-02-JN10-AWD3000-03-JN10-AWD4000-02-JN10-AWD4000-03-JN10-AWD4000-04-JNPort sizeRc1/43/81/43/81/2Proof pressureMax. operating pressureGauge port sizeAmbient and fluid temperatureNominal filtration ratingOil mist density on secondary sideElement lifeConstructionNote 1)Flow ratel / min (ANR)180450Drain storagecm 32345Set pressure rangeMPa0.05 to 0.85Note 2) 0.05 to 0.2Application• With drain guideRc1/4(Without valve mechanism)• Fitting attached tobonnet breathing hole(Applicable tubing O.D.ø6)Note 1) Secondary side pressure: In case of 0.5 MPa. (The rated air flow rate varies with the set pressure.) Be careful if the flow exceeds the rated flow rate+C149, oil will flow out to the secondary side.Note 2) Optional specification.Note 1) At compressor exhust density of 30mgf/Nm 3Note 2) Small amount of grease is used for O-ring of the case and other O-rings.AccessoryDescriptionPressuregauge1.5MPa1.0MPaRc1/4–5 to 60°C (No freezing)0.01µm (95% scavenging particle diameter)Note 1) Note 2) Max.0.1mgf/Nm 3 (0.01 mgf/Nm 3 or less ≅0.008 ppm before oil saturationm)2 yearsNon-relief typeAccessory (Option)/Part NumberBracketModel1.0MPa0.2MPaFor 10-AWD3000B320G49-10-02G49-4-02Note) The pressure gauge for 0.2MPa settings is G49-4-02 for 0.4MPa.Use the factory mounted bracket and pressure gauge.Part NumberFor 10-AWD4000B420G49-10-02G49-4-02