Pneumatic Clean Series

Solenoid Valve 10-VQ1000/2000408How to Order Valves10 - V Q 1 1 3 0 Y - 5 B - C6Clean seriesActuation2 position single(A)(B)4 212VQ10005 1 3(R1)(P)(R2)2 position double (Latching)(A)(B)4 2Metalseal5 1 3(R1)(P)(R2)(A)(B)4 25 1 3(R1)(P)(R2)RubbersealCylinder port sizeC3 — For ø3.2 One-touch fittingC4 — For ø4 One-touch fittingC6 — For ø6 One-touch fittingM5 — M5 threadManual overrideNil — Non-locking push type (tool required)B — Lock type (tool required)C — Locking type (lever)Note) The standard manual override for pilot valve is provided for double latching type.Coil voltage5 — 24VDC/With light/surge suppresser6 — 12VDC/With light/surge suppresserFunctionNil — Standard (1W): Double (latching) typeY — Low wattage (0.5W) specifications: Single typeSeal type0 — Metal seal1 — Rubber sealS Kit (Serial Transmission Kit)How to Order Manifold Assembly/Example3mSingle solenoid(24VDC)10-VQ1130Y-5-C6(4 sets)D side U side123--------------StationsDouble solenoid(24VDC)10-VQ1230Y-5B-C6 (4 sets)DirectionalControl ValveD-sub connectorcableF kitD-sub connector kitManifold base (8 stations)10-VV5Q13-08BFU2Cylinder portport sizeC6: For ø6One-touch fittingNote 2)SKitOABCDF1HWithout SI unitGeneral purpose type SI unitSI unit for Mitsubishi (MELSEC-A)SI unit for OMRON (SYSMAC)SI unit for Sharp (New Satellite)SI unit for NKE Corporation UNI-WIRE System (16 points)SI unit for NKE Corporation UNI-WIRE H System (16 points)Note 1)Maximum8 stationsNote 1) Using special wiring, semi-standard specifications with a larger maximum numberof stations are available.Note 2) Consult SMC regarding serial transmission kits by Matsushita Electric Industrial Co., Ltd.,Allen Bradley Co. , SUNX Limited, FUJI ELECTRIC CO.,LTD. and OMRON Corporation.10-VV5Q13-08BFU2 ······1 set (F kit 8 station manifold base part No.)∗ 10-VQ1130Y-5-C6 ······4 sets (Single solenoid part No.)∗ 10-VQ1230-5B-C6 ······4 sets (Double latching solenoid part No.)∗ To order valves and options mounted onto the manifold at the factory,prefix the part number of the solenoid valve and other equipment withan asterisk (∗).Specify the valves to be installed below the manifold part number. If thelayout is complicated, give descriptions on a manifold specification sheet.389