Pneumatic Clean Series

Solenoid Valve 10-VQ100438JIS symbol(A)21 3(P) (R)Normally closed (N.C.)(A)21 3(P) (R)Normally open (N.O.)Latching type(A)21 3(P) (R)SpecificationsValve specificationsElectrical specificationsTypeValve typeFluidMax. operating pressureMin. operating pressureFlowcharacteristics1223Note 1)Response timeAmbient and fluid temperatureLubricationManual overrideMounting orientationImpact/Note 4)Vibration resistance 150/30m/s2EnclosureWeightRated coil voltage DCAllowable voltage fluctuationType of coil insulationPower consumption DCElectrical entryC[dm 3 /(s·bar)]bCvC[dm 3 /(s·bar)]bCvLow wattage type (0.5W)1W typeDirect acting 3 port poppet type (N.C.)Air, Inert gas0.7MPa0MPa0.055 0.0420.220.270.0140.0110.0830.0450.280.280.0210.012ON: 3.5ms,OFF: 2.5ms ON: 3.5ms,OFF: 2ms–10 to 50°C Note 2)Not requiredNon-locking push type/Locking type (tool required) Note 3)FreeDust proof12.6g (L, M plug connector, Without sub-plate)24V, 12V±10% of rated voltageEquivalent to class B0.5W (21mA)1W (42mA)GrommetPlug-in, L plug connector, M plug connector(With light/surge suppresser)Note 1) According to JIS B8374-1993. A value with light/surge voltage suppressor (clean air).Dispersion accuracy of ±1ms.Note 2) Use dry air to prevent condensation when operating at a low temperature.Note 3) Locking type is option.Note 4) Impact resistance: No malfunction resulted in an impact test using a drop impact tester. The test wasperformed each time in the axial and right angle directions of the main valve andarmature, for both energized and deenergized states.Vibration resistance: No malfunction resulted in a one-sweep test in a 8.3 to 2000Hz range in theaxial and right angle directions of the main valve and armature, for bothenergized and de-energized states (value in the initial stage).DirectionalControl ValveSpecifications for OptionsValvespecificationsElectricalspecificationsTypesItemsModelMax. operating pressure12Flowcharacteristics23Response timePowerconsumptionElectrical entryC[dm 3 /(s·bar)]bCvC[dm 3 /(s·bar)]bLatching type AC type110-VQ110L- 10-VQ110- 2 0.7MPa0.0420.270.0110.0450.28Large flow type10-VQ110U-0.6Mpa0.140.260.0360.140.25Cv0.0120.036Note 2)5ms or less 6.5ms or less 5ms or less24VDC 1W (42mA) — 0.7W (29mA) Note 2)12VDC 1W (83mA) — 0.7W (29mA) Note 2)100VAC 0.6VA (6mA) 0.5VA (5mA) —Plug-in, L plug connector, M plug connectorNote 3)(With light/surge suppresser)Note 1) According to JIS B8374-1993. A value with light/surge voltage suppressor (clean air).Note 2) Inrush 3.1 W (10ms after energization), Holding 0.7WNote 3) The grommet is available only for normally open type (without light/surge voltage suppressor).Only 1W DC specification is available with the normally open type.419