Pneumatic Clean Series

Solenoid Valve 10-VQ1000/2000432ModelSeries Number of solenoids Model10-VQ10002 positionSingleDouble (Latching)Metal seal 10-VQ1170YRubber seal 10-VQ1171YMetal seal 10-VQ1270Rubber seal 10-VQ127114/2 (PA/B)C[dm 3 /(s·bar)] b Cv0.560.710.560.710.150.200.150.20Flow characteristics Note 1)0.130.170.130.174/25/3 (A/BR1/R2)C[dm 3 /(s·bar)] b Cv0.120.160.120.160.140.190.140.19Response time Note 2)ms15 or less20 or less15 or less20 or lessNote 1) Cylinder port size C6Note 1) According to JIS B8375-1981 (At supply pressure of 0.5MPa with light/surge voltage suppressor. The value differs with the pressure and the quality of air.)0.600.800.600.80Weightg67SpecificationsValvespecificationsValve typeFluidMax. operating pressureMin. operatingpressureAmbient and fluid temperatureLubricationManual overrideEnclosureRated coil voltageAllowable voltage fluctuationElectricalType of coil insulationspecificationsPower consumption DC 24VDC(Current)12VDCNote 1) Use dry air to prevent condensation when operating at a low temperature.Precautions to Install Threaded Fitting AssemblyThreaded fitting assemblys used for this manifold are not mounted on themanifold base or valve in order to improve installation efficiency ofconnecting the fittings to the port.Install the threaded fitting following the steps below.1. Screw in the fitting to the ancillary threaded fitting assembly.Metal seal0.7MPaAir, Inert gasRubber seal0.7MPaSingle0.1MPa0.15MPaDouble (Latching)0.18MPa0.18MPa3 positions 0.15MPa 0.2MPa–10 to 50°C Note 1) –10 to 50°C Note 1)Not requiredPush type/Option: Locking type (tool required, lever)Dust proof12V,24VDC±10% of rated voltageEquivalent to class B0.5W DC (21mA)0.5W DC (42mA)Precautions1. Be careful not to scratch or stain the O-ring of the fitting assembly.It may cause air leakage. To prevent exhaust air at EXH from pressurization (0.3 MPa or more)by throttling, double side piping is recommended for EXH port.(Otherwise delay in response or air leakage may result.)DirectionalControl ValveThe fitting to be usedO-ringThreaded fitting assembly2. Insert the threaded fitting assembly into the manifold port.Valve3. Insert the ancillary clip into the groove on the bottom surface ofthe valve.413