Pneumatic Clean Series

High Precision Digital Pressure Switch 10-ZSE40/ISE40646SpecificationsRated voltage rangeOperating pressure range/Set pressure rangeProof PressurekPaMPaSet pressureresolution(Note1)FluidPower supply voltageCurrent consumptionSwitch outputRepeatabilityHysteresis modeHysteresisWindow comparator modeResponse time (With anti-chattering function)Output short circuit protectionDisplayDisplay accuracyIndicator lightAnalog output (Note2)Auto shift input (Note3)Environmentalresistancekgf/cm 2barpsimmHgInHgEnclosureAmbient temperature rangeAmbient humidity rangeWithstand voltageInsulation resistanceVibration resistanceShock resistanceTemperature characteristicsPort sizeLead wireWeight (Weight)10-ZSE40F (Compound pressure)–100.0 to 100.0kPa–100.0 to 100.0kPa500kPa0.1—0.0010.001 0.010.0010.010.010.11—0.1—Air, Non-corrosive gas, Non-flammable gas12 to 24VDC±10%, ripple (p-p)10% or less55mA or lessNPN or PNP output, Max. load pressure: 80mAMaximum applied voltage: 30VDC (For NPN Output)Residual voltage : 1V or less (For load current 80mA)±0.2%F.S. ±1digit or lessVariableFix (3digit) (Note4)2.5ms or less (24ms, 192ms, 768ms with anti-chattering function)Yes3 1/2 digit LED (Sampling frequency: 5 cycles/1 sec)±2%F.S. ±1digit or less (At ambient pressure of 25 ± 3°C)Green LED(OUT1: Lights up when ON) Red LED (OUT2: Lights up when ON)Output voltage: 1 to 5V±5%F.S. or less (Within rated voltage range)Linearity: ±1%F.S. or lessOutput impedance: approx.1kΩ10-ZSE40 (Vacuum pressure)0.0 to –101.3kPa10.0 to –101.3kPa10-ISE40 (Positive pressure)0.000 to 1.000MPa–0.100 to 1.000MPa1.5MPa—Output voltage: 1 to 5V±2.5%F.S. or less (Within rated voltage range)Linearity: ±1%F.S. or lessOutput impedance: approx.1kΩNo-voltage input (Solid state switch or reed switch), 5 ms or longer inputIP65Operating: 0 to 50°C, Stored: –10 to 60°C (With no freezing and condensation)Operating and store: 35 to 85% RH (With no condensation)1000VAC for 1 minute, between entire lead wires and enclosure50 MΩ or more (Measured with 500VDC megameter), between entire lead wires and enclosure10 to 500 Hz double vibration with 1.5 mm width or 98m/s 2 (10G), whichever is smaller, and in X, Y, Z direction each (Without energization)980m/s 2 (100G) in X, Y, Z direction each (Without energization)±2% F.S. or less against measured pressure at 25°C in the temperature range of 0 to 50°C01: R1/8,M5 X 0.8 T1: NPT1/8,M5 X 0.8 W1: Rc1/8C4: ø4 With One-touch fitting C6: ø6 With One-touch fitting M5: M5 female thread5 wire oil-proof heavy duty cable (0.15mm 2 )01/T1 type: Approx. 60g, W1 type: Approx.80g, C4/C6/M5 types: Aprox. 92g (Each including 0.6m as lead wire length)Note 1) For the type with unit switching function(For a type without unit conversion function, the unit is fixed on the SI unit (kPa or MPa).)22Note 2) In case of 10-ZSE40(F)/ISE40-- 62Note 3) In case of 10-ZSE40(F)/ISE40-- 3070Note 4) The value is represented as 0.03 to 0.04psi in the 10-ZSE40F (Compound pressure) psi notation.Note 5) The value is within the range ±0.01psi in thr 10-ZSE40F (Compound pressure) psi notation.0.02NoteThe possible setting ranges of auto shift function types are as follows.Set pressure range–100.0 to 100.0kPa10.0 to –101.3kPa–0.1 to 1.000MPaPossible set range–100.0 to 100.0kPa–101.3 to 101.3kPa–1.000 to 1.000MPaPressure SwitchO-ringFKM627