Pneumatic Clean Series

533Series KPClean One-touch FittingsFor BlowingRecommended Applicable TubingTubing materialTubing O.D.Polyolefin: Series TPHSoft polyolefin: Series TPSø4, ø6, ø8, ø10, ø12Note 1) Polyurethane tubing: Series TU, Nylon tubing: Series TSoft polyurethane tubing: Series TS is also applicable. However, the cleanliness performance will decline.Note 2) Polyurethane tubing may fold when inserted due to its softness. Hold the tube while keepingthe insertion length at the end and insert it all the way in slowly and securely until its end isfelt to touch the bottom.SpecificationsParticle generation gradeFluidGrade 1 Note 1)Air, Nitrogen gas, Water (Pure water) Note 2)Max. operating pressure (20°C)Operating vacuum pressureProof pressure (20°C)1MPa–100kPa3MPaNote 3)Ambient and fluid temperatureThreads–20°C to 80°C, In case of water 0 to 60°C (No freezing)JIS B0203 (Tapered pipe thread)Note 1) Refer to particle generation grade classifications.(Front matter 14)Note 2) Consult SMC regarding other fluids.Note 3) The maximum operating pressure is the value at 20°C. Refer to the operating pressure curvefor other temperatures.Main Parts MaterialBodyStudChuckGuide, Stopper screw, Drive bushingCollet, Release buttonSeal, O-ring, CushionPolypropylene resinPolypropylene resinSUS304SUS304Polypropylene resinEPDMCautionSeries KP is a line of special one-touch fittings for use in clean room blowing andwashing lines. Consult SMC regarding other types of applications.Seal material: The durability of EPDM with respect to mineral oils is inferior, which makes itunsuitable for piping in general pneumatic equipment.514