Pneumatic Clean Series

Wide Opening Parallel Type Air Gripper 11-MHL2250SpecificationsBore size (mm)FluidActionOperating pressure MPaAmbient and fluid temperatureRepeatabilityLubrication(Note) Effective holdingforce (N) at 0.5 MPa10 16 20 25 32AirDouble acting0.15 to 0.6 0.1 to 0.6–10 to 60°C±0.1Not required14 45 74 131 228Note) The holding position is 40 mm with a cylinder inside diameter of 10, 16, 20 or 25 and 80 mm with a cylinder inside diameter of 32.∗Refer to data on page 2.2-3 of Best Pneumatics e for the holding force at each holding point.Auto Switch Specifications(Refer to Page 2.2-1 of Best Pneumatics e for detailed specifications and auto switches not in the following table.)StateSolid state 2-wire systemswitch 3-wire systemAuto switch part No.D-Y59BD-Y59ALoad voltage24VDC (10 to 28VDC)28VDC or lessLoad current range Indicator light Application5 to 40mA24VDC relay, PLC40mA or less 24VDC relay, PLCCautionRefer to pages 7 to 16 of Front matter for common precautions for clean series. Refer to pages 214 to 215 forcommon precautions for air grippers.Dimensions11-MHL2-10D2-ø4.5(Body mounting hole)CABø3H9 +0.025 0 depth 32-M4 X 0.7 thread depth 5(Mounting thread)D9Air Gripper4343H9 +0.025 0 depth 34-M4 X 0.7 thread depth 8(Mounting thread)ø18H9 +0.043 0 depth 1.5Closed FClosed JView A (Closed)M5 X 0.8Finger closing port2-M5 X 0.8Vacuum suction port9H99M5 X 0.8Finger opening portø6ø65.5Width across flats 8(4 positions)4-M5 X 0.8(Piston rod andrack screw)ø12.4(46)1583112.50.574418.2208.4 16.8Auto switch mounting groove(4 positions)A157104 4 7Open F10G20344-M4 X 0.7 through(Thread for mounting attachment)11-MHL2-10D11-MHL2-10D111-MHL2-10D2A385472B365270C6783101D264260E7294112F92134172G116158196H243957J96124162(mm)231