OMRON Sysdrive 3G3HV - Detector Cooling Section

Acceleration/Deceleration Time Switching Command (Set Value = 12)
Operation Example
Output
frequency
Acceleration
time 1
Deceleration
time1
Deceleration
time2
Acceleration
time2
Forward
rotation/
Stop (S1)
Acceleration/Deceleration
time switching reference
External Baseblock Command (Set Value = 13 or 14)
The baseblock command can be input remotely to the Inverter by setting
n035 to 13 (i.e., the NO contact is ON) or to 14 (i.e., the NC contact
is OFF).
The baseblock is the status of the Inverter with output turned OFF. The
motor will coast to a stop if the baseblock command is input to the
Inverter. However, the Inverter will hold the output frequency.
The Inverter will have output that will change its frequency step by step
to reach the same output frequency if the Inverter is released from the
baseblock command.
If the baseblock command is, however, input remotely to the Inverter after
the Inverter receives the stop command, the output frequency held
by the Inverter will be 0 Hz.
Speed Search Command (Set Value = 15 or 16)
The Inverter in speed search operation restarts the motor without stopping
the motor while the motor is coasting.
The Inverter in speed search operation makes it possible to smoothly
switch over power supply to the motor from commercial power supply to
the output power of the Inverter.
Program a sequence to input the run command and speed search command
simultaneously or the run command after the speed search command.
The speed search command will be ignored if the run command
is input earlier than the speed search command.
Operation Example
Output frequency
Maximum frequency
or set frequency
Minimum baseblock
time (n053)
Forward
rotation/Stop
(S1)
5 ms min.
Speed search
operation
Minimum baseblock time (n053) or more
Speed search
command