OMRON Sysdrive 3G3HV - Detector Cooling Section

n029
Setting range
Inching Frequency Reference
0 to maximum
frequency
Unit Set with n024 Default setting
6.0
• The inching frequency reference must be set with n029 if an inching
frequency is required.
• The inching command must be selected to use the inching frequency
reference.
n030
Output Frequency Upper Limit
Setting range 0 to 100 Unit % (Maximum
frequency ratio)
Default setting
100
n031
Output Frequency Lower Limit
Setting range 0 to 100 Unit % (Maximum
frequency ratio)
Default setting
0
• Set the upper limit and lower limit of the output frequency in 1% units
based on the maximum frequency set with n012 as 100%.
• The Inverter will operate at the lower limit of the output frequency set
with n031 if the frequency reference used by the Inverter is set to 0.
The Inverter will not, however, operate if n031 is set to a value smaller
than the minimum output frequency set with n017.
Internal frequency
reference
Output frequency
upper limit (n030)
Output frequency
lower limit (n031)
Set frequency reference
n032
Setting range 10% to 200%
of rated output
current of Inverter
Motor Rated Current
Unit A Default setting
See note
Note The default-set value varies with the Inverter model. Refer to the following table.
Set Values
• Set the rated input current of the motor to determine electronic thermal
protection characteristics for the motor.
• The parameter n032 is set to the rated input current of the maximum
applicable motor before shipping.