OMRON Sysdrive 3G3HV - Detector Cooling Section
OMRON Sysdrive 3G3HV - Detector Cooling Section
OMRON Sysdrive 3G3HV - Detector Cooling Section
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Preparation Procedure<br />
Installation<br />
Install the Inverter according to installation conditions. Refer to <strong>Section</strong> 2–1–2. Installation<br />
Conditions.<br />
Check that all the installation conditions are met.<br />
Wiring<br />
Connect the power supply and peripheral devices. Refer to <strong>Section</strong> 2–2. Wiring.<br />
Select peripheral devices that meet the specifications, and wire them correctly.<br />
Turning the Power ON<br />
Check the necessary items, then turn the power ON.<br />
Check that the power voltage is correct and the power input terminals (L1 (R), L2 (S), and<br />
L3 (T)) are wired correctly. Supply three-phase, 200 to 230 VAC (50/60 Hz) to the 200-V<br />
Inverter and three-phase 380 to 460 VAC (50/60 Hz) to the 400-V Inverter.<br />
Check that the motor output terminals (T1 (U), T2 (V), and T3 (W)) and motor are connected<br />
correctly.<br />
Check that the control circuit terminals and controller are connected correctly.<br />
Checking the Display Status<br />
Check the Inverter for errors.<br />
If everything is normal, the data display will show the data selected with a monitor item<br />
indicator.<br />
If the Inverter is error, the data display will show data indicating that the Inverter is error.<br />
Refer to <strong>Section</strong> 4 Operation for details.<br />
Setting the Parameters<br />
Use the Digital Operator to set parameters required for operation. Refer to <strong>Section</strong>s 3–2–1,<br />
3–2–2, .<br />
Set each parameter as described in this manual.<br />
Test RUN<br />
Use the Digital Operator to rotate the motor. Refer to <strong>Section</strong> 3–3. Test Run..<br />
Check that the motor is rotating normally.<br />
Operation<br />
Basic operation (The Inverter operates with basic settings). Refer to <strong>Section</strong> 3–4. Basic Operation.<br />
Applied operation (The Inverter performs energy-saving control, PID control, or other applied<br />
control). Refer to <strong>Section</strong>s 3–5–1, 3–5–2.<br />
Refer to <strong>Section</strong> 3–4 Basic Operation for operation with basic parameters only.<br />
Refer to <strong>Section</strong> 3–4 Basic Operation and <strong>Section</strong>s 3–5–1, 3–5–2 Applied Operation for<br />
energy-saving control, PID control, frequency jumping, error retrying, or S-shaped acceleration<br />
and deceleration.<br />
Refer to <strong>Section</strong>s 3–5–1, 3–5–2 Applied Operation for parameters in detail.
Change language