OMRON Sysdrive 3G3HV - Detector Cooling Section

Free Running Stop 1 with Timer (n004 = 2)
Output frequency
Deceleration rate determined by deceleration
time 1 set with n020 or deceleration time 2
set with n022.
Run command
ignored.
Set the deceleration time
to a period longer than
the time required by the
motor to coast to stop.
Run command
Note The run command will not be accepted during the minimum baseblock time set with n053
if the time required by the motor to coast to stop is shorter than the minimum baseblock
time.
Free Running Stop 2 with Timer (n004 = 3)
Output frequency
Deceleration rate determined by deceleration
time 1 set with n020 or deceleration time 2
set with n022.
Set the deceleration time
to a period longer than
the time required by the
motor to coast to stop.
Run command
Note The run command will not be accepted during the minimum baseblock time set with n053
if the time required by the motor to coast to stop is shorter than the minimum baseblock
time.
n005
Forward/Reverse Rotation Selection
Setting range 0, 1 Unit --- Default setting
0
• Set the rotation direction of the motor so that the motor will rotate in the
set direction when the forward rotation command is input.
Set Values
Set
Description
value
0 The motor seen from the load side rotates counterclockwise.
1 The motor seen from the load side rotates clockwise.
• The motor is deemed to be rotating forward if the motor seen from the
load side is rotating counterclockwise unless the forward rotation
direction of the motor defined by the manufacturer is opposite.
n006
Reverse Rotation-inhibit Selection
Setting range 0, 1 Unit --- Default setting
0
• Select whether reverse rotation will be available or not.