OMRON Sysdrive 3G3HV - Detector Cooling Section

Function
No.
Name
Error retry n056 Number of
error retries
n057 Selection of
error output
during error
retry
Note
Note
Description
Setting
range
Set number of error retries. 0 to 10
[0]
0: Turns ON error output while error retry 0, 1
is performed.
1: Turns OFF error output while error retry
is performed.
[0]
User
setting
1. For a 400-V Inverter, if the carrier frequency is set to a value higher than the default
setting, the Inverter overload “OL2” detection value will decrease in consideration of
an increase in the heat that will be generated by the change in the carrier frequency.
2. Default settings vary with the Inverter model.
Function No. Name Description Setting
range
Frequency n058 Jump frequency
Set center value of jumping frequency in 0.0 to
jump
1 1-Hz 1Hz units.
400.0
n059 Jump frequency
2 value is set to 0.0.
Frequency jump function will be invalid if
[0.0]
n060 Jump frequency
Set jump range of jumping frequency in 0.0 to
1-Hz units.
25.5
range
[1.0]
Accumulated
operation
time
n061
n062
n063
Total operating
time
function
selection
Total operating
time 1
(rightmost
4 digits)
Total operating
time 2
(leftmost 2
digits)
DC braking n064 DC braking
current
n065
n066
Stopped
DC braking
time
Startup DC
braking
time
0: Accumulates power-on time.
1: Accumulates running time
Set accumulation start time in 1-h units.
Permits accumulated operation time monitor
to function. (Same as U-11 and U-12)
Accumulated operation time (h) = n063 x
10,000000 + n062
Max. value: 279,620 (h) (Returns to 0
when accumulated operation time exceeds
279,620 h)
Set DC control current in 1% units based
on rated output current of Inverter as
100%.
Set stop DC control time and start DC
control time in 1-s units.
DC control will be invalid if value is set to
00 0.0.
0, 1
[1]
0 to
9,999
[0]
0 to 27
[0]
0 to
100
[50]
0.0 to
10.0
[0.5]
0.0 to
10.0
[0.0]
User
setting