OMRON Sysdrive 3G3HV - Detector Cooling Section

Function No. Name Description Setting
range
Slip compensation
Motor rated
0.0 to
slip
9.9
Others
n109
(see
note 1)
n110
(see
note 1)
n111
(see
note 1)
n112
(see
note 1)
n113
(see
note 1)
n114
(see
note 1)
n115
(see
note 1)
Motor noload
current
Slip compensation
primary
delay time
Operation
selection
when Digital
Operator
is disconnected
Frequency
detection
width
Local/Remote
Key
selection
When use slip compensation function, sets
the motor rated slip in % units of motor
rated frequency.
Sets the motor no-load current in % unit of
motor rated current (n032).
Slip compensation primary delay time is
set in s unit.
Note Usually setting is not necessary. Adjust
when slip compensation responsiveness
is low, or speed is not stabilized.
When responsiveness is low, decrease
the set value.
When speed is not stabilized, increase
the set value.
Sets the operation when the Digital Operator
is disconnected.
0: Disabled (operation continues even if
the Digital Operator is disconnected.)
1: Enabled (CPF0 or CPF1 is detected
with Digital Operator. Inverter output
will be cut off and error contact will be
operated.)
Sets the width of Frequency Agreement
(n040, n041) and frequency detection
(n073) in Hz unit.
Used to set the Operation mode by switching
to the Remote mode using the Local/
Remote Key.
0: Run signals that are input during mode
switching are ignored. (Input Run signals
after switching the mode.)
1: Run signals become effective immediately
after switching to the Remote
mode.
For the manufacturer’s use. (Not setting)
[0.0]
0 to 99
0.0 to
25.5
[2.0]
0, 1
[0]
0.0 to
25.5
[2.0]
0, 1
[0]
See
note 2
User
setting
Note
Note
1. These constant are disabled for 1010 to 1015 of PROM number (U-10).
2. Setting range and default settings vary with the Inverter model.