OMRON Sysdrive 3G3HV - Detector Cooling Section

Parameters in Detail
Refer to the following for the functions of the parameters used with the Inverter
not in energy-saving or PID control operation.
n001
Setting range 0, 1, 2, 3, 6,
and 7
Group 1:
Group 2:
Group 3:
Parameter Write Prohibit Selection/Parameter
Initialization
Unit --- Default setting
• The parameters used by the Inverter are classified into the following
three groups.
n001 to n034
n035 to n049
n050 to n108 (Up to n102 can be used.)
• The Inverter is default-set so that only parameters of group 1 can be
set and checked and the parameters of groups 2 and 3 can only be
checked.
Set Values
Set
Description
value
0 The parameters n001 can be set and checked and the parameters n002 to n108 can be
only checked.
1 The parameters of group 1 (i.e., n001 to n034) can be set and checked and the
parameters of groups 2 and 3 (i.e., n035 to n049 and n050 to n108) can be only
checked.
2 The parameters of groups 1 and 2 can be set and checked and the parameters of group
3 can be only checked.
3 The parameters of groups 1, 2, and 3 can be set and checked.
6 All parameters will be set to default-set values.
7 All parameters will be initialized with a three-wire sequence. (see note 2)
Note
Note
1. Do not set n001 to any value other than the above.
2. Refer to n035 on below for the 3-wire sequence.
n002
Operation Mode Selection
Setting range 0 to 3 Unit --- Default setting
• The Inverter has four operation modes. Refer to the following table
and select one of the modes with n002.
Set Values
Set
value
Run command Frequency reference Operation mode indicator of Digital
Operator
Remote operation Analog input
0 Digital Operator Digital Operator Not lit Not lit
1 Control circuit terminals
Digital Operator Lit Not lit
2 Digital Operator Control circuit terminals
(see note 2)
Not lit
Lit
3 Control circuit terminals
Control circuit terminals
(see note 2)
Lit
Lit
1
3