OMRON Sysdrive 3G3HV - Detector Cooling Section
OMRON Sysdrive 3G3HV - Detector Cooling Section
OMRON Sysdrive 3G3HV - Detector Cooling Section
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Function No. Name Description Setting<br />
range<br />
Slip compensation<br />
Motor rated<br />
0.0 to<br />
slip<br />
9.9<br />
Others<br />
n109<br />
(see<br />
note 1)<br />
n110<br />
(see<br />
note 1)<br />
n111<br />
(see<br />
note 1)<br />
n112<br />
(see<br />
note 1)<br />
n113<br />
(see<br />
note 1)<br />
n114<br />
(see<br />
note 1)<br />
n115<br />
(see<br />
note 1)<br />
Motor noload<br />
current<br />
Slip compensation<br />
primary<br />
delay time<br />
Operation<br />
selection<br />
when Digital<br />
Operator<br />
is disconnected<br />
Frequency<br />
detection<br />
width<br />
Local/Remote<br />
Key<br />
selection<br />
Sets the motor rated slip in % units of motor<br />
rated frequency when slip compensation<br />
is used.<br />
Sets the motor no-load current in % units<br />
of motor rated current (n032).<br />
Slip compensation primary delay time is<br />
set in s units.<br />
Note Usually setting is not necessary. Adjust<br />
when slip compensation responsiveness<br />
is low or when speed has<br />
not stabilized.<br />
When responsiveness is low, decrease<br />
the set value.<br />
When speed has not stabilized, increase<br />
the set value.<br />
Sets the operation when the Digital Operator<br />
is disconnected.<br />
0: Disabled (operation continues even if<br />
the Digital Operator is disconnected.)<br />
1: Enabled (CPF0 or CPF1 is detected<br />
with Digital Operator. Inverter output<br />
will be cut off and error contact will be<br />
operated.)<br />
Sets the width of frequency agreement<br />
(n040, n041) and frequency detection<br />
(n073) in Hz units.<br />
Used to set the Operation mode by switching<br />
to the Remote mode using the Local/<br />
Remote Key.<br />
0: Run signals that are input during mode<br />
switching are ignored. (Input Run signals<br />
after switching the mode.)<br />
1: Run signals become effective immediately<br />
after switching to the Remote<br />
mode.<br />
For the manufacturer’s use. (Do not set.)<br />
0 to 99 30<br />
0.0 to<br />
25.5<br />
0, 1 0<br />
0.0 to<br />
25.5<br />
0, 1 0<br />
See<br />
note 2<br />
Default<br />
setting<br />
0.0<br />
2.0<br />
2.0<br />
See<br />
note 2<br />
Note<br />
Note<br />
1. These constants are disabled for 1010 to 1015 of PROM number (U-10).<br />
2. Setting ranges and default settings vary with the Inverter model.
Change language