Administration Guide - Avaya Support

VMSC - Messaging Application Server (MAS) Configuration
To configure Telephony Interface Analog properties, complete the following
fields:
! Playback Volume Enter a value for the playback volume. The range is -8
(minus 8) through 8. For C-LAN and Inband integrations, the default value
is 2.
Avaya recommends that you enter 2 for 30-port, 24-port, 8-port, or
4-port cards.
! Number of Ports Enter the number of ports that connect the MAS with the
PBX. The default is set during installation.
Note: If you increase the number of ports, you must restart the MM
Messaging Application Server service before you can administer
them.
! Enable DTMF Call Progress Tones (Available only if your system uses
Brooktrout boards).
Select this check box to configure selected ports to receive DTMF tones
from the PBX.
! Configure the port fields listed in the grid:
— Enable or disable ports, as required, by selecting or clearing the
check boxes to the left of each port. All ports are selected by default.
—Port The port number is read only.
— Extension Enter the port extension number. You can enter up to 10
digits. This field is blank by default.
— Incoming Ring Count Enter a number to specify the number of
rings before a call on the port is answered. The range is 1 through 9,
and the default is 1.
— Primary Id Enter the first part of the PBX integration identifier,
known as the logical terminal number (LTN), for serial integration
only. You can enter up to 10 characters and digits (including & * #
and ,). This field is blank by default.
Note: This field is applicable to DMI-4 and RS-232 integrations only.
Leave this field blank for C-LAN and inband integrations.
Avaya Modular Messaging Release 3.1 with the Avaya MSS
February 2007 MAS Administration Guide
4–15