Administration Guide - Avaya Support

Caller Applications Editor
Menus and Icons available from this node
! Action > Change Access Key Displays the Change Key dialog box,
where you can change the key press the caller must use to access the
selected application (action) node. See Change Key Dialog Box on page
6-65.
! Action > Set Application Start Sets the selected node as the start point of
the caller application. The node then displays a green arrow ( ).
! Action > New > Application Node Launches the Add Node dialog
box, where you can create an application (action) node. It then appears as
a sub-node beneath the application (action) node selected in the tree. See
Add Node Dialog Box on page 6-39.
! Action > Delete Deletes the selected application (action) node. If the
selected node is referenced by other nodes, the system displays a dialog
box with information on the referenced nodes.
! Action > Properties Displays the Properties dialog box for the
selected application (action) node. You must use this dialog box to set
properties that apply to the application (action) node. It is not configured
correctly until you do so. See Properties Dialog Box on page 6-42.
Avaya Modular Messaging Release 3.1 with the Avaya MSS
6–28 MAS Administration Guide
February 2007