PDF user manual for CopperEdge 150

SrcMaskSrcAdrsDstMaskDstAdrsIpProtocolSrcPortCompareSrcPortDstPortCompareDstPortAction= Source Subnet Mask Address= Source IP Address= Destination Subnet Mask address= Destination IP Address= Filter Protocol Identifier= None, equal, less, greater, not equal= Source port= None, equal, less, greater, not equal= Destination Port= Filter Action: pass, block, chainA full set cmfilter command would take the form shown in thefollowing example:CRAFT> set cmfilter [1.4.7, 1] function=insertsrcadrs=n.n.n.n srcmask=n.n.n.n dstadrs=n.n.n.ndstmask=n.n.n.n ipprotocol=0 srcport=5 srcportcompare=eqdstport=8 dstportcompare=ne action=passThe cmFilter table is sorted by PII (SNMP first index), and thenby filter-number (SNMP second index).Sorting in the Filter TableIndex filter_number Filter Data1.4.1 1 • • •1.4.1 2 • • •.4.1 3 • • •1.4.2 1 • • •1.4.2 2 • • •: : :1 2 7 (After any filter operation, that filter list is renumbered 1 through N,consecutively, with no gaps in the sequence. For example, if a filterlist has five existing entries and you add filter number 99 to the list, itwill become filter number 6. Use this method to add filters to the endof a list when you don’t know exactly how many filters are on the list.&RSSHU(GJH,QVWDOODWLRQDQG2SHUDWLQJ*XLGH