PDF user manual for CopperEdge 150

4. On the local machine, change to the new softwaredirectory:ftp> lcd c:\newce200Local directory now C:\newce2005. On the CE150, delete the SCM file in the ce200budirectory:ftp> del scm250 Command accepted.6. Upload the new SCM file from the local machine to theCE150:ftp> put scm200 Port set okay150 Opening BINARY mode data connection########################################################################################################################################################################################################################################################################################################################################226 Transfer complete2254784 bytes sent in 50.94 seconds 1 2 7 (When transferring software using FTP, a certain amount of delay isnormal. Do not interrupt the process and try to start over—the originalfile on which the processor is running has been deleted from flash.Note also that while upload of the SCM file is in progress, theCopperCraft command line interface will not respond to commands.Wait until the SCM upload is complete before you enter furthercommands. If upload of the SCM file has not completed after 20minutes, contact Copper Mountain’s Technical Assistance Center.7. Upgrade the Code subdirectory:a) Change to the Code subdirectory on both the CE150and local machines:ftp> cd code250 Changed directory to “P:/ce200bu/code”ftp> lcd codeLocal directory now C:\newce200\codeb) On the CE150, delete all *.bgz or *.bin files, one byone:ftp> del bc.bgz or del bc.bin250 Command acceptedc) Upload the new code files (*.bgz) from the localmachine to the CE150:ftp> mput *.bgzmput bc.bgz?Enter y for each file to confirm the upload.200 Port set okay150 Opening BINARY mode data connection####$SSHQGL['8SJUDGLQJ6\VWHP6RIWZDUH