PDF user manual for CopperEdge 150

,33ROLF\2YHU(WKHUQHW1 2 7 (Performance implications when using the Ethernet port of the CE150as a WAN interface, using the IP Policy netmodel, are not clear. If youestablish other network connections over a WAN port (FR, ATM,V.35) along with a connection over the Ethernet port, you may haveperformance degradation on one link or all of the links. Also,restriction to a single virtual bridge group in VWAN over Ethernet maypresent a security problem on your network.Any DSL link can also be policy routed to a specific host on anEthernet LAN through the CE150 Network (Ethernet) port asfollows.First, if the CE150 Ethernet port has not yet been configured,assign its IP addres. Second, set its networking model and encapsulationtype parameters. For example:CRAFT> set cmiface [1.3.1] ipaddr=192.168.1.1netmask=255.255.255.0 netmodel=ip encapsulationtype=noneSet SuccessfulCRAFT> get cmiface [1.3.1]The response will display all objects in the cmIface group for thespecific instance (the Ethernet interface).Group: cmIfaceTableInstance: [1.3.1]PII = 1.3.1.0IfIndex = 1.3.1.0Name= EthernetPortAdditionalInfo= System MasterNetModel= IPIpAddr = 192.168.1.1NetMask = 255.255.255.0MacAddr= 0.80.56.34.da.87BurnedInMacAddr= 0.80.56.34.da.87FarEndAddr = 0.0.0.0DestPii = 0.0.0.0CMCPCompatible= NoEncapsulationType = NoneFwdMode= Full-IPPix = 1As shown, the CE150 Ethernet port is configured as full IP. Toconfigure the DSL port for policy routing, configure its IP addressand netmask, destination PII (the System Control ModuleEthernet port, 1.2.1) and far-end address (the IP address of theEthernet host machine). For example:CRAFT> set cmiface [1.4.1] ipaddr=200.10.10.1netmask=255.255.255.252 destpii=1.3.1 farendaddr=192.168.1.2netmodel=ip encapsulationtype=rfc1483Set Successful&RSSHU(GJH,QVWDOODWLRQDQG2SHUDWLQJ*XLGH