PDF user manual for CopperEdge 150

8. Set the VC for data for DHCP. You are configuring theCE150 so that it can dynamically assign an IP addressto the host on the data VC. You are assuming theexistence of a DHCP server upstream from the CE150and its default router.CRAFT> set cmdhcp [1.4.13.22] ipaddress=10.0.21.2netmask=255.255.255.255 function=dhcpforwardserveripaddr=10.0.25.2When you perform a get, you will see this table:CRAFT> get cmdhcp [1.4.13.22]Group: cmDHCPTableInstance: [1.4.13.22]PII = 1.4.13.22RowStatus= ActiveIpAddress = 10.0.20.2NetMask = 255.255.255.0DefaultRouter = 0.0.0.0DNSServer = 0.0.0.0Function= DHCPForwardServerIPAddr = 10.0.25.2CircuitID= CRAFT-1.4.13.229. Set the VC for voice on the DSL port (1.4.13.22). Youmust specify the number 22 for a VC. You cannot useany VC for voice except VC 22. You cannot use anynetmask for voice other than 255.255.255.255.CRAFT> set cmiface [1.4.13.22] netmodel=hdiaipaddr=10.0.21.2 netmask=255.255.255.255destpii=1.2.1.21 encapsulationtype=ip-1490When you perform a get, you will see this table. Onceagain, make sure the object, CMCPCompatible, showsa setting of Yes. If it does not, perform another Setcommand with CMCPCompatible=Yes.CRAFT> get cmiface [1.4.13.22]Group: cmIfaceTableInstance: [1.4.13.22]PII = 1.4.13.22IfIndex = 1.4.13.22Name = ""GroupName = ""AdditionalInfo = ""NetModel= HDIAIpAddr = 10.0.21.2NetMask = 255.255.255.255MacAddr= ff.ff.ff.ff.ff.ffBurnedInMacAddr = ff.ff.ff.ff.ff.ffFarEndAddr = 0.0.0.0DestPII = 1.2.1.21CMCPCompatible = YesEncapsulationType = IP-1490FwdMode= HDIAPix = 2590ServiceClass= None&KDSWHU9RLFHRYHU'6/