PDF user manual for CopperEdge 150

5. Set the VC for voice on the WAN port with a VPI(range=0-15) and a VCI (range=0-511). But, reserve thevpi=0 and vci=511 combination for ATM loopbacktesting.CRAFT> set cmatmvcl [1.2.1.21] rowstatus=create vpi=0vci=201 adminstatus=upWhen you perform a Get on the VC to check your work,you will see this table:CRAFT> get cmatmvcl [1.2.1.21]Group: cmAtmVclTableInstance: [1.2.1.21]PII = 1.2.1.21Vpi = 0Vci = 201AdminStatus= UpOperStatus= UpLastChange= 0 day 0 hour 0 min 0.0 secAalType= Aal5Aal5CpcsTransmitSduS = 1600Aal5CpcsReceiveSduSi = 1600RowStatus= ActiveTransmitTrafficDescr = 1TransmitTrafficDescr = 2OAMState= adminDown(0)OAMAdminState = disabledOAMAutoLBState = disabledOAMManualLBCmd = noneOAMManualLBCmdStatus = noneOAMLBInterval = 5OAMLBTimeOut = 15OAMTxAISCells = 0OAMRxRDICells = 0OAMRxAISCells = 0OAMTxRDICells = 0OAMTxLBRequestCells = 0OAMRxLBResponseCells = 0OAMRxLBRequestCells = 0OAMTxLBResponseCells = 0OAMRxUnsupportedCell = 0OAMTxDiscards = 0OAMRxDiscards = 06. Set the VC for voice on the WAN port with a voicegateway type ID and a voice gateway IP address. Thevoice gateway IP address must be on the same subnetas the IAD IP addresses:CRAFT> set cminterfaceoptions [1.2.1.21]voicegatewaytypeid=4 voicegatewayipaddr=10.0.21.1When you perform a Get on the VC to check your work,you will see this table. Do not try to setJitterSpeedTradeOff:CRAFT> get cminterfaceoptions [1.2.1.21]Group: cmInterfaceOptionsTableInstance: [1.2.1.21]PII = 1.2.1.21VoiceGatewayType = TollBridgeVoiceGatewayIpAddr = 10.0.21.1MaxVoiceChannels = 255JitterSpeedTradeoff = NoneJitterControlStatus = UncontrolledRowStatus= ActiveVoiceGatewayTypeId = 4&KDSWHU9RLFHRYHU'6/