PDF user manual for CopperEdge 150

+HOSIXO6KRUWFXWV*HWDOODQG)LQGIn addition to the standard SNMP commands, the CopperCraftinterface provides two special command, Getall and Find. Theyare briefly described below. For more complete informationabout these commands, see the CopperEdge 150 CopperCraftReference and MIB Definitions manual.GetallThe Getall command allows you to review the status of all objectsfor all instances of a specified group at the same time. Theoutput is more condensed than the output for a Get command.The basic syntax is:CRAFT> getall mib_groupSince the list could have hundreds of entries, the screen will fillup and stop at four or five entries. To view additional entries,press any key except Esc. Continue paging until you find theentries you want or until you reach the end of the list. To quitthe listing at any time, press Esc.FindThe Find command provides an easy way of compiling lists ofinterfaces based on common criteria. The lists are useful fortroubleshooting and record-keeping. You can use the find commandin several different ways.To specify up to three objects and their values for all instances,the basic syntax is:CRAFT> find mib_group object1=value1...object3=value3To specify up to three objects and their values starting with aspecific instance, the basic syntax is:CRAFT> find mib_group [instance] object1=value1...object3=value3You can include up to five additional object names after thethree objects and values to refine the output. The system willreturn only the values for the instance and the object names forthose entries that matched the specified criteria.&KDSWHU,QLWLDO&RQILJXUDWLRQ