PDF user manual for CopperEdge 150

)HDWXUHV'6)UDPH5HOD\0RGXOHNo special commands or objects are needed for configuring eitherFrame Relay or ATM WAN VCs. All parameters are accessiblefrom the existing CE150 MIB tables.The Frame Relay WAN VCs currently support:• RFC-1973, point-to-point protocol over Frame Relay• RFC-1483, encapsulation (FUNI)• RFC-1490, bridged or routed-IP encapsulation• NNI on WAN Links• RFC-1315, DLCMI and link (PVC) performance/errormonitoring• Traffic Shaping, with settings for Committed InformationRate (CIR), Committed Bursts (CB), and Excess Bursts(EB)• Link Management Interface (LMI), with protocols LMIRev1, ANSIT1-617-D, and Q9.33-Annex-A• IP packet filtering on VCs•'6$700RGXOHThe ATM WAN VCs currently support:• RFC-1483, multi-protocol encapsulation over ATM• RFC-1490, multi-protocol encapsulation over Frame• RFC-2364, point-to-point protocol over ATM• ATM Permanent Virtual Circuits (Switched VirtualCircuits not supported at this time)• ATE, functioning as an ATM Host• Traffic Shaping, with service categories (ubr, nrtVBR,rtVBR) and with settings for Peak Cell Rate (PCR),Sustained Cell Rate (SCR), Maximum Burst Size (MBS),and CDV (Cell Delay Variation)• OAM Fault Management, with Alarm Indication Signals(AISs) and Remote Defect Indications (RDIs) along withfunctions for automatic and manual (diagnostic)loopbacks• virtual connections (no virtual path tunneling• IP packet filtering on VCs•&RSSHU(GJH,QVWDOODWLRQDQG2SHUDWLQJ*XLGH