PDF user manual for CopperEdge 150

Type Severity DescriptionPortMisprovisioned Minor Sent by the System Control Module for a DSL port when theline trains but is not configured; that is, the operational stateof the port is Up, but the port is not configured.This event alerts the operator that an end user is trying toconnect on a port that is not configured.Information included in the event:Status stringCleared by: ManuallyTrap: cmPortMisprovisionedPowerSupplyFault Major Sent by the System Control Module when a Power Supplyfault is detected.Information included in the event:NoneCleared by: PowerSupplyClearTrap: cmPowerSupplyFailureRateFallbackAlarm Minor Sent by the DSL line module when the link trains at ratelower than the configured data rate.Information included in the event:Port PIICurrent data rateCleared by: RateFallbackClearTrap: cmRateFallbackRedundancyChanged Minor Sent by the System Control Module when a change in theredundancy state (Enable/disable) is detected.Information included in the event:SCM board PIIRedundancy is enabled or disabledCleared by: ManuallyTrap: cmRedundancyChangeRedundancyConflict Minor Sent by the Secondary System Control Module when a secondarymodule thinks it should be locked as primary, but theother side is already locked. Both modules are trying toassume the Primary role.Information included in the event:IndexCleared by: ManuallyTrap: cmRedundancyConflictRoleChanged Major Sent by the System Control Module when its redundancyrole (Primary/Secondary) changes.Information included in the event:SCM board PIINew primary SCM board PIIFailover was automatic or manualCleared by: ManuallyTrap: cmRoleChange$SSHQGL[&(YHQWDQG$ODUP5HIHUHQFH