PDF user manual for CopperEdge 150

ce150(1.3)>This default prompt consists of the system name (ce150), as definedin the Name object of the cmSystemTable, plus the slotnumber of the active System Control Module (1.3). Since allCE150s initially have this default prompt, we recommend youchange the system name in the cmSystemTable to a moremeaningful name. You cannot change the slot number.In this manual, we show the command line prompt as:CRAFT>CopperCraft LogoutWhen you are ready to log out of the system, enter exit, quit,or logout.If you changed any system settings and did not save the configuration,the following prompt is displayed:CE configuration has been changed.Save the configuration?(Y / y)>Enter Y or y to save the configuration. If the save was successful,the following messages are displayed:.....CE configuration save succeeded.2000/11/14-15:33:17 USER LOGGED OUTIf you enter a response other than Y/y, or if you do not respondwithin 30 seconds, the configuration will not be saved, but thelogout process will continue.If you entered Y/y to save the configuration but do not want towait for the save process, press Esc. The configuration will besaved and the logout process will continue.&RPPDQG/LQH,QWHUIDFHIn general, commands and other data can be entered withoutregard to case; either capital letters or lowercase letters are acceptable.However, to specify a directory path on a file server,use lowercase letters, as many servers are case-sensitive andwill not download their software if commands are not lowercase.If a long command line wraps, or for any reason you are indoubt about what the entire line actually contains, and in whatorder, type ^L (Control-L) to refresh the display of the entirecommand. For more information about line editing, see Copper-Craft Line Editor on the next page.&KDSWHU,QLWLDO&RQILJXUDWLRQ