PDF user manual for CopperEdge 150

1 2 7 (When creating IMUX bundles, do not attempt to preconfigure theindividual DSL Member ports with cmIFace or cmSubIface beforeassigning them to a bundle. If you try to assign configured ports to anIMUX bundle, the cmBundle command will fail, and the system willreturn an error message. If this happens, use cmIface to reset theDSL member port causing the error to NetModel=None. Configurationof NetModel and the resultant forwarding mode can only be done byconfiguring the bundle.7. Using cmSubIface, create the virtual circuit(s) for theIMUX bundle. In the process, set the destination PII topoint to the desired virtual circuit on the WAN link.CRAFT> set cmsubiface [1.51.1.16] rowstatus=createdestpii=1.2.1.200Set Successful8. Using frCircuit, create the entry for the virtual circuiton the WAN link if it does not already exist. At the sametime, set the values for the Frame Relay congestionmanagementparameters.CRAFT> set frcircuit [1.2.1.200] throughput=n1committedburst=n2 excessburst=n3Set Successful&KDSWHU$GYDQFHG&RQILJXUDWLRQ