PDF user manual for CopperEdge 150

7. When the module is seated in the connector, ensurethat the extraction levers lay flat (module-insertedposition), and use your fingers to screw in the tworetainer screws.Finger tighten only; do not over-torque.8. Reconnect the front-panel cables disconnected instep 2.9. Apply power to the system and wait for boot-up tocomplete.10. Connect to the Craft port and use a terminal emulationprogram to log in to the CE150.11. Configure the CE150 to talk to the rest of the network:a) Set the netmodel, IP address, and netmask of theCE150.CRAFT> set cmiface [1.3.1] netmodel=ipipaddress=xxx.xxx.xxx.xxx netmask=255.255.255.xxxb) Set the default route for this CE150.CRAFT> set iproute [0.0.0.0] mask=255.255.255.xxxnexthop=xxx.xxx.xxx.xxxc) Set the SNMP command strings.CRAFT> set cmoperator [public] context=snmpprivilege=viewCRAFT> set cmoperator [private] context=snmpprivilege=provisiond) Save the new configuration.CRAFT> set cmsystem command=save12. If necessary, load the software.13. Restore the saved configuration:• Set FTP to Binary mode and copy the Configurationfile from the workstation.• Or, refer to Restoring a Backed Up Configuration onpage 111 to reinstate the saved systemconfiguration.14. Restart the system.CRAFT> set cmsystem command=restart1 2 7 (If you are upgrading to a Buffer Control Module 2, you must alsoupgrade to a System Control Module 3. The BCM-2 will not work witha SCM-1 or SCM-2.&RSSHU(GJH,QVWDOODWLRQDQG2SHUDWLQJ*XLGH