PDF user manual for CopperEdge 150

Diagnostic port, 29, 33Ethernet port, 29, 33Quad T1 ports, 36*G.dmtPort class, 179G.liteModule-24 class, 179G.litePort class, 179Getall command, 51gzip utility, 260+hardware restart, 209HDLC DSL link protocol, 8HDLC PPP DSL link protocol, 8hot-swap, 9humidity, operating, 5,IDSLModule-24 class, 178IDSLPort class, 179IDSLTimingLossAlarm, 240IDSLTimingLossClear notification, 243IEC 320 AC power cable, 15IEC 320 power connector, 23input power specificiations, 5input/output impedance, 7InterShelfTrunk class, 179/LCRestart command, 49, 209LEDsAC Power module, 38, 172Buffer Control Module, 38, 172DS1 (Quad T1) module, 175DS3 WAN module, 175Quad T1, 36SDSL module, 38, 176System Control Module, 38, 39, 174WAN ATM module, 40Link class, 179link connections, DSL, 26LinkDown alarm, 240LMI Rev 1.0a protocol, 8Local Craft Interface cable, 16loginCopperCraft, 44electronic Release Notes, 10operator, 246Radius, 54, 105, 106login promptsRead Community, 55Write Community, 55LoginFail event notification, 246LoginSaturated alarm, 240LoginSucceed event notification, 246LoginSuspended alarm, 240Logout event notification, 246logout, from CopperCraft, 45logsAlarm, 9, 180, 182Audit, 180, 183Event, 9, 180, 188loopbacksDS1, 193DS3, 194EOC, 191LoopStatusChange event notification, 2460MaintFailed alarm, 240management sessionsCraft serial port, 9FTP, 9SNMP, 9Telnet, 9messagesNotification, 185Warning, 185modem port, 174modem port settings, 34modems33,600 Kbps analog, 6module statusAC Power Module, 38AC Power module, 172Buffer Control Module, 38, 172DC power, 172DSL, 172SDSL module, 38, 176System Control Module, 38, 39module, soft restart, 208modulesDS1 (Quad T1) WAN, 7DS3 ATM WAN, 7DS3 Frame Relay WAN, 7EIA-449 (CCITT V.36) WAN, 7X.21 WAN, 71Net 1 connector, 33Net 2 connector, 33Netopia-SDSL class, 180network connection cable, 17network, connecting to, 57Networking Models, 225notificationAlarm Clearing, 177Event, 177Notification message, 185notificationsAtmVccUp, 242&RSSHU(GJH,QVWDOODWLRQDQG2SHUDWLQJ*XLGH