PDF user manual for CopperEdge 150

3. Set the VC on the DSL port. Use a PII such as1.4.12.528 and specify a VPI and VCI. They mustmatch the ones on the CPE. Typically, they are 0 and32. The number of the VC itself must be 528. It cannotbe any other number for rfc1483.CRAFT> set cmatmvcl [1.4.12.528] vpi=0 vci=32adminstatus=upPerform a Get on the VC and you will see this tableCRAFT> get cmatmvcl [1.4.12.528]Group: cmAtmVclTableInstance: [1.4.12.528]PII = 1.4.12.528Vpi = 0Vci = 32AdminStatus= UpOperStatus= UpLastChange= 0 day 0 hour 0 min 36.0 sec(2000/04/14-14:42:13)AalType= Aal5Aal5CpcsTransmitSduS = 1600Aal5CpcsReceiveSduSi = 1600RowStatus= ActiveTransmitTrafficDescr = 04. Set the NetModel and the EncapsulationType for theDSL port. Use the same PII, 1.4.12, that you used instep 3. The VC number is not necessary. SetCMCPCompatible to No (the default is Yes).CRAFT> set cmiface [1.4.12] netmodel=ipencapsulationtype=rfc1483 cmcpcompatible=noPerform a Get on the port and look at the table:CRAFT> get cmiface [1.4.12]Group: cmIfaceTableInstance: [1.4.12.0]PII = 1.4.12.0IfIndex = 1.4.12.Name = ""GroupName = ""AdditionalInfo = "NetModel= IPIpAddr = 10.10.1.1NetMask = 255.255.255.0MacAddr= ff.ff.ff.ff.ff.ffBurnedInMacAddr = 0.0.0.0.0.0FarEndAddr = 0.0.0.0DestPII = 0.0.0.0CMCPCompatible = NoEncapsulationType = rfc1483FwdMode= Full-IPPix = 14ServiceClass= D&RSSHU(GJH,QVWDOODWLRQDQG2SHUDWLQJ*XLGH