PDF user manual for CopperEdge 150

7. Set the VC for data on the first DSL port (1.4.13). Donot specify a number for the VC. The software uses thedefault of VC 528.CRAFT> set cmiface [1.4.13] netmodel=hdiaipaddr=10.0.20.2 netmask=255.255.255.255destpii=1.2.1.20 encapsulationtype=rfc1483The current netmask means only one host can beattached to the IAD. To attach four hosts, use a255.255.255.252 netmask.The following diagram shows addressing for data andvoice VCs on the first DSL port.HDIA Data Group (10.0.20.0)HDIA Voice Group (10.0.21.0)1Host8PhonesIADIP Addr: 10.0.20.2Net mask: (/32)PII: 1.4.13VC: 528IP Addr: 10.0.21.2Net mask: (/32)PII: 1.4.13VC: 22HDIADSLAMIP Addr: 10.0.20.0Net mask: (/26)PII: 1.2.1.20IP Addr: 10.0.21.0Net mask: (/26)PII: 1.2.1.21IP Addr: 10.0.20.1IP Addr: 10.0.21.1DefaultRouterVoiceGatewayHDIA Netmodel—Configuring IP Addresses and NetmasksWhen you perform a get, you will see this table. Makesure the object, CMCPCompatible, shows a setting ofYes. If it does not, perform another Set command withCMCPCompatible=Yes.CRAFT> get cmiface [1.4.13]Group: cmIfaceTableInstance: [1.4.13.0]PII = 1.4.13.0IfIndex = 1.4.13.0Name = ""GroupName = ""AdditionalInfo = ""NetModel= HDIAIpAddr = 10.0.20.2NetMask = 255.255.255.255MacAddr = 0.60.58.1.43.12BurnedInMacAddr = 0.60.58.1.43.12FarEndAddr = 0.0.0.0DestPII = 1.2.1.20CMCPCompatible = YesEncapsulationType = rfc1483FwdMode= HDIAPix = 15ServiceClass= D&RSSHU(GJH,QVWDOODWLRQDQG2SHUDWLQJ*XLGH