PDF user manual for CopperEdge 150

Note that this use of FarEndAddr is very different from its functionin configuring WAN virtual circuits. Note also that, if theDestPII is the Ethernet port on the System Control Module,then the FarEndAddr must be a separate IP address, but itmust be on the same subnet as the Ethernet Port.The configured DSL interface should be similar to the followingexample.Group: cmIfaceTableInstance: [1.4.1]PII = 1.4.1IfIndex = 1.4.1NetModel= IPIpAddr = 200.10.10.1NetMask = 255.255.255.252MacAddr = 0.60.12.34.56.78BurnedInMacAddr = 0.60.12.34.56.78FarEndAddr = 192.168.1.2DestPii = 1.3.1.0CMCPCompatible= YesEncapsulationType = rfc1483FwdMode= Policy-IPPix = 14A key difference between policy routing over Ethernet versuspolicy routing over WAN is that over Ethernet, the far-end addressof the DSL interface is configured with the IP address ofthe Ethernet host. In contrast, over a WAN link, the far-end address(FarEndAddr) is not significant for the DSL link. You don’tneed to configure it.&KDSWHU5RXWLQJ)RUZDUGLQJ0DQDJLQJ/LQNV